The meshbox is the 2.0 update to the original box object in BZFlag 1.0. The main difference between the box and the Meshbox is that the meshbox supports new features in BZFlag 2.0, such as physics drivers and textures.
A very basic meshbox will include:
meshbox position 0 0 0 # x-pos, y-pos, height rotation 0 # rotation in degrees size 10 10 10 # x-len, y-len, height end
As with the box object, position defines where the meshbox should be located. Rotation defines the angle it should be rotated to (about the Z-axis), and size defines how big or small the object should be. Now, if you're looking for something a little fancier, you can try code similar to this:
meshbox name example position 0 0 0 rotation 0 size 10 10 10 shift 0 0 0 shear 0 0 0 scale 0 0 0 spin 0 0 0 0 outside matref my_cool_wall top matref my_cool_roof phydrv example_physics obstacle end
Valid parameters for a meshbox are:
|name||defines the name of meshbox, often unused.|
|position||defines the position of the meshbox in X-pos, Y-pos and the height of the meshbox in Z.|
|rotation||defines a rotation around the Z axis for the meshbox, in degrees.|
|size||defines the distance from the center to the side of the meshbox in X and Y, and the total height of the meshbox in Z.|
|shift||shift the meshbox (repeatable).|
|scale||defines the scale of the meshbox in x,y, and z, 1 is the default, lower values make it smaller (repeatable).|
|spin angle||rotate the meshbox around a vector by angle. The vector <nx, ny, nz> must be a unit vector. Because the BZFlag client doesn't clip objects against the ground, it is advisable to ensure that the meshbox is rotated up and away from the ground. Otherwise, the meshbox will appear to be super-imposed on the ground, rather than embedded into it. (repeatable).|
|phydrv||reference to a predefined physics driver.|
|matref||reference to a predefined material.|
So what's the difference here? Well, this object will be treated as an obstacle. The outside walls (as opposed to inside, top, or bottom) will appear with the "my_cool_wall" material, and the roof (top) will have "my_cool_roof." Of course, if you want a material on all sides of the object, you can simply omit the "top" specification at the start of the line, and simply have: "matref my_cool_material." Also, you can specify a physics driver to the object, to influence tank behavior a bit.
By default, a meshbox will have red brick walls, and a grey stone roof. However, if a material is specified by the map creator, the appearance depends on the designer's choosing. Contrary to a Box, a height 0 meshbox at ground level is not visible.
The meshbox was added in BZFlag 2.0.0.